The 300MP electronic level switch is a multi point replacement for 1 to 4 mechanical float level switch.
1,2, 3 or 4 independent probe channels in one electronic enclosure means the installed cost per detection point can be appreciably lower than traditional float
level switches. The system incorporates a probe fault circuit that can distinguish
whether probes are in a healthy state. The process fault circuit indicates a change
in the normal operating state of each probe (e.g. from steam to water). The Probe
Insert Assembly is welded into pipework or vessels at the selected detection
points. This provides internal shrouding of the probe for defined water conductivities
and a robust housing for external protection of the probe. Multiple Probe
Pipework Assemblies can be supplied to suit particular applications.
The system is a micro-processor based system that uses a handheld programmer
for setup and adjustment.
KEY FEATUES
4 independent probe channels
Micro-Processor based with handheld programmer
Conductivity Settings for different water purity conditions
Dual Power Supplies
Local Indication using Red & Green high visibility LEDS
Remote Display via the integral RS485 compatible port
Probe Validation for both horizontal and vertical installation
IP65 Rating of enclosure for external use
5 Relay outputs for probe channel output and system fault
